The operation material of plastic granulator is plastic products such as bottle pieces, although compared with metal, etc., it is relatively easy to cut and crush, but in our daily use of scrap granulator, we should pay attention to the maintenance and use of the machine, the following Xiaobian will introduce the precautions and maintenance methods of plastic granulator in daily use.
In the process of our daily use of plastic granulator, we need to follow the instructions to strictly implement the operation, so as to extend it, let's follow us to understand it. Do not use low-quality return material with metal impurities or sediment. Metal objects that may fall into the feed can not be placed near the feed port. Placing metal objects into the feed hopper can aggravate the wear of the screw and barrel or produce stuck and damaged phenomena. Must pay attention to fire safety, prohibit smoking next to the machine carrying lighters non-staff can not be around to watch, but can not be hands-on operation to often add lubricating oil to the parts of the machine to increase fluency
Doing this can greatly reduce the failure of the plastic granulator and increase the service life.
Maintenance method of plastic granulator
First of all, the plastic granulator should be placed in a ventilated position to ensure that the working heat of the motor is dissipated and its life is extended. The bearing should be filled with lubricating oil regularly to ensure the lubricity between bearings; Check the tool screws regularly. After the new plastic granulator is used for 1 hour, use the tool to tighten the knife and fix the screw of the knife to strengthen the rigidity between the blade and the tool holder. In order to ensure the sharpness of the cutting tool, the tool should be regularly checked to ensure its sharpness, and reduce the unnecessary damage of other components caused by the lack of the blade clock: When replacing the tool, the gap between the knife and the fixed knife: more than 20HP is broken, the thinner the recovered material, the gap can be appropriately adjusted: Before the second start, the remaining debris in the machine room should be cleaned first to reduce the starting resistance:
The inertia cover and pulley cover should be opened regularly, and the ash outlet under the blue plate should be cleaned. Because the plastic granulator room discharged powder into the rotating shaft bearing, the plastic granulator should be kept well grounded.
